Campbell HydroSense II Manual de Instruções descarregar pdf (Página 18)

HS2 and HS2P

These parameters are soil specific and grouped as “soil profiles”. The

HydroSense II holds up to 10 soil profiles labeled “SOIL 1” through “SOIL

10”.

Some soil profiles are preset to default values. These values may be used or

overwritten as desired, but take care to record what soil type is used for each

profile. The default soil profiles are described in TABLE 6-1, Default Soil

Profiles.

TABLE 6-1. Default Soil Profiles

Soil No “Dry” “Wet” Rod Length Soil Description

1 7% 15% 20 cm Sand

2 10% 20% 20 cm Sandy Loam

3 18% 35% 12 cm Sandy Clay

4 15% 30% 12 cm Loam

5 20% 40% 12 cm Silty Clay

6 17% 35% 12 cm Clay Loam

6.4.2 Configuring Soil Profiles

When Deficit Mode is enabled (Section 7.3.4, Deficit Display (p. 17)), soil

profiles are accessed from the main screen (p. 14) of the HydroSense II. To

select the current soil profile (“SOIL 1” in the preceding figure), press the

button. The soil profile number will be highlighted. To open the soil profile

list, press .

The soil profile list should be displayed. Use to move through the list

to the desired soil profile and press .

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 45 46

Sem comentários

Campbell HydroSense II Manual de Instruções Página 18