Campbell IPn3Gb Manual do Utilizador descarregar pdf (Página 5)

CC5MPX Digital Camera and IPn3Gb

Cellular Modem

1. Introduction

This application note is intended to provide guidance for setting up the IPn3Gb

modem and CC5MPX camera for the purpose of transmitting images and video

via Ethernet. Transfer options discussed include Email (SMTP) and FTP. There

is also discussion of power management, where the CC5MPX can be used to

control power to the modem.

For general CC5MPX and IPn3Gb configuration details, refer to their

respective manuals. If you have general questions or encounter any issues

during the procedure, please contact a Campbell Scientific Measurement

Consultant by phone (780-454-2505) or by email

(dataloggers@campbellsci.ca).

1.1 Modem Account – Public versus Private IP Address

When setting up an account with your mobile data service provider, it is

important to obtain an account that has a public IP address. The account can

make use of either dynamic or static IP configuration.

If the modem account does not have a public IP address, then only outgoing

communications will be possible. This means that the camera will only be able

to send pictures or videos out via FTP or email, and it will not be possible to

initiate communications from the Internet to the camera.

In contrast, if a public IP address is provided, then full two-way

communications will be possible. This means that you will also have access to

the CC5MPX web interface and FTP server from the Internet. This is required

for access to camera settings and diagnostics information, and also for remote

file access.

For further details, please see the IPn3Gb manual.

2. Initial Modem Setup

The following procedures assume that:

 You have obtained an appropriate account from your mobile data

provider

 The appropriate SIM card has been inserted properly into the modem

 You have the required account information and setting details from

your mobile data provider, and the modem is active on the network.

The easiest way to configure the IPn3Gb modem is to connect the modem

directly to your computer using the Ethernet port. Be sure that the unit is

powered on and has been allowed to warm up for about 2 minutes.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Sem comentários

Campbell IPn3Gb Manual do Utilizador Página 5