Campbell COM210 Manual de Instruções

INSTRUCTION MANUALCOM210 Telephone ModemRevision: 10/05Copyright (c) 1997-2005Campbell Scientific, Inc.

COM210 Telephone Modem 6 4. Troubleshooting When the Campbell Scientific software cannot establish a link to the remote datalogger that is connected

COM210 Telephone Modem 7 To comply with FCC rules and regulations, all repairs on the COM210 modem must be performed by Campbell Scientific, Inc. or a

COM210 Telephone Modem 8

A-1 Appendix A. Modifying the Non-Volatile Memory To modify the COM210’s settings, one must communicate directly to the COM210. This may be accompli

Appendix A. Modifying the Non-Volatile Memory A-2 FIGURE A-1. LoggerNet Screen A.2 Remote Communication to the COM210 To remotely communicate with

Appendix A. Modifying the Non-Volatile Memory A-3 9227SC532ARS232 to CS I/OPOWERMADE IN USASN:PERIPHERALPCLogan, UtahTIPRINGGNDCAMPBELLSCIENTIFICINC.

Appendix A. Modifying the Non-Volatile Memory A-4 3: Extended Parameters (P63) 1: 48 Option ;0 2: 68 Option ;D 3: 84 Option ;T 4: 13 Opt

Appendix A. Modifying the Non-Volatile Memory A-5 RESULT CODES: 0 OK 1 Connect 2 Ring 3 No Carrier 4 Error 5 Connect 1200 Baud 6 No Dial Tone 7 Bus

Appendix A. Modifying the Non-Volatile Memory A-6 This is a blank page.

B-1 Appendix B. CS I/O Connection B.1 CS I/O 9-Pin Connection The pin out of the connector is shown in Figure B-1. The direction of the signal rela

Warranty and Assistance The COM210 TELEPHONE MODEM is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and workmanship unde

This is a blank page.

C-1 Appendix C. Theory of Operation C.1 Theory of Operation The COM210 modem is used to transmit data over bandwidth-limited channels such as teleph

This is a blank page.

D-1 Appendix D. FCC Warning to Users of Class A Computing Devices This equipment generates, uses, and can radiate radio frequency energy, and if not

This is a blank page.

E-1 Appendix E. IC Information Industry Canada (IC) was formerly known as DOC. CP-01, Issue 8, Part I Section 14.1 “NOTICE: The Industry Canada labe

This is a blank page.

This is a blank page.

Campbell Scientific CompaniesCampbell Scientific, Inc. (CSI)815 West 1800 NorthLogan, Utah 84321UNITED [email protected]

i COM210 Telephone Modem Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat

COM210 Telephone Modem Table of Contents ii List of Figures 1. COM210 ...

1 COM210 Telephone Modem 1. Introduction 1.1 General Description The COM210 Modem is a 9600 baud phone modem employing the Hayes AT command set. It

COM210 Telephone Modem 2 2. Specifications • Bell 212A, CCITT V.22, and CCITT V.32 compatible • Full duplex at 9600 (default setting) and 1200 baud

COM210 Telephone Modem 3 Current Campbell Scientific dataloggers provide 12 VDC to the COM210 via the SC12 cable (Figure 2). Older dataloggers do not

COM210 Telephone Modem 4 SE12 34 56 78H1234LDIFFHEX1HLHLLP2P112VGDC ONLYCAUTIONLUGGROUNDPOWER INWIRING PANELCR1000PERIPHERAL PORTRS-232 (Not Isolated)

COM210 Telephone Modem 5 TIPRINGGNDCAMPBELLSCIENTIFICINC.COM210 MODEMMADE IN USAS/N1002Complies with Part 68, FCC rules. FCC Registration No. B9QUSA