Campbell SC105 CS Guia do Utilizador

SC105 9-Pin to RS-232-DCE Interface User Guide Issued 19.10.10 Copyright © 2004-2010 Campbell Scienti

SC105 9-Pin to RS-232-DCE Interface 2 2. Specifications RS-232 9-Pin Female Connector Pin-out: Pin No. I/O Name Description 1 In DCD Data Carrier

User Guide 3 RS-232 Baud Rates The SC105 will support the following baud rates: 1200, 9600, 19200, 38400, 57600, 115200 RS-232 Parity and Data The SC1

SC105 9-Pin to RS-232-DCE Interface 4 SC105) while setting SC105 parameters on the RS-232 port, although CS I/O communications would be inactive until

User Guide 5 'PC/PDA mode': DTR and RTS are both driven to 5 V. 'Modem mode': DTR will be driven to +5 V when the CS I/O interfa

SC105 9-Pin to RS-232-DCE Interface 6 For transmission, the RAD modem uses a cable made of two pairs of twisted wires with a shield. Data rates up to

User Guide 7 includes hardware for mounting to ground lug of CSI enclosures models ENC 10/12, ENC 12/14, or ENC 16/18). Spark gap wiring is straight

SC105 9-Pin to RS-232-DCE Interface 8 5.3 Testing RAD Modem Communication The modem communication link is divided into the following three sections:

User Guide 9 6. CDMA Modem Application In most modem applications the SC105 can be used with the factory defaults. This sets the SC105 up as modem e

CAMPBELL SCIENTIFIC COMPANIES Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com • info@campbel

Guarantee This equipment is guaranteed against defects in materials and workmanship. This guarantee applies for twelve months from date of delivery.

PLEASE READ FIRST About this manual Please note that this manual was originally produced by Campbell Scientific Inc. primarily for the North American

i Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab for links to spe

1 SC105 9-Pin to RS-232-DCE Interface Figure 1. SC105 9-Pin to RS-232-DCE Interface 1. General Description The SC105 (Figure 1) is used to interfac