Campbell CR510 Manual do Operador descarregar pdf (Página 220)

TD ADDENDUM  SECTION 1. FUNCTIONAL MODES

AD-1-6

The *D15 entries are sent when the program is

retrieved. They can also be set like other *D

settings via the DLD file.

1.8.9 ALLOCATE MEMORY FOR GENERAL

PURPO

SE FILES

*D16:xx ;allocate xx 64K byte chunks of

m

emory for general purpose files.

The area comes out of final storage

space. Files are stored in a circular

buffer (ring memory) in this space.

1.8.10 VIEW ROUTING TABLE

*D17 allows viewing the current routing table

inf

ormation. This is view only.

TABLE 1.8-12. Values in Routing Table

Key

Entry Display

Comments

*D 13:00 Enter Command

17A Enter the view routing table

c

ommand

01:xxxx ;pakbus address of

destination

node

02:xxxx ;via nei

ghbor with xxxx pakbus

address

03:xxxx ;a worst case response ti

me

metric (seconds)

(Repeats for next destination node.)

1.8.11 SET PAKBUS ROUTER BEACON

INTERVAL

TABLE 1.8-13. Set Beacon interval

Key

Entry Display

Comments

*D 13:00 Enter Command

18A Enter the beacon interval

s

ettings

A 01:xxxx Enter the Interval (seconds) for

SDC7

A 02:xxxx Enter the Interval (seconds) for

SDC8

A 03:xxxx Enter the Interval (seconds) for

CS I/O

Pin Enabled, 9600 baud

A 04:xxxx Enter the Interval (seconds) for

RS232, 9600 baud (

CR23X

only)

1.8.12 PAKBUS NEIGHBOR FILTER

In some networks, sending beacons can be

dis

ruptive. Entering values in the *D19 mode

disables the beacon. A PakBus datalogger with

nonzero *D19 settings will not send beacons

and will only respond to beacons from nodes

with addresses in the neighbor list.

Instead of sending beacons, the datalogger will

s

end “hello” messages to neighbors in the list to

determine if it can communicate with them.

Neighbors (or potential neighbors) should be

nodes that communicate directly with the

datalogger without going through a router.

Note that this list is not automatically cleared by

c

ompiling a new program. (It may be changed

if the new program contains *D19 entries.) It

can be edited by changing entries. Once 0 is

entered for a neighbor address, all entries

beyond the 0 entry are cleared.

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 263 264

Comentários a estes Manuais

Sem comentários