Campbell CC5MPX Manual de Instruções Página 24

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 117
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 23
CC5MPX Digital Camera
15
5.3.1 Status LED
The Status LED located in the center of the button provides some useful diagnostic
information about the camera. Table 5-1 describes the LED behavior.
Table 5-1 Setup Button LED Indicator
LED
CC5MPX State Other
Continuously
Off
No power or the camera is in
one of the following Low
Powered Modes:
x Partially On
x Deep Sleep
x Off Mode
Pressing the Setup Button will
force the camera to exit any of
the low powered modes and
remain Fully on for a period
of 5 min with the LED rapidly
flashing
Slow Flash
1 sec on, 3
sec off
Normal Operation in Fully On
Power mode
Rapid Flash
Exit from low power state.
The camera is being kept on
by:
x
Timeout (from the
Setup Button press)
x Communications
x
Asserted External
Trigger
x Image or video
acquisition
Continuously
On
The camera is booting up.
The booting up process takes
approximately 90 sec.
The camera will be required
to boot up whenever:
x Power
is first applied
to it
x
The camera is exiting
the Off Power mode
to perform an
operation.
5.3.2 Setup Button
The primary function of the Setup button is to wake the camera from any of the
power saving modes that it may be in. Once the Setup button is pushed the
CC5MPX enters a fully powered mode for 5 minutes. During this interval, you are
able to access the camera via Ethernet or RS-232/485 and make any necessary
configuration changes. If no communications occur during the 5 minute window,
the camera will return to its configured power saving mode and continue normal
operation.
The secondary function of the Setup button is to facilitate a power down procedure.
If the button is held for a period of 10 seconds, the camera will completely shut
down for a period of 10 minutes. During this interval you are able to remove power
from the camera and avoid possible corruption of the memory card. This function
is also available through the camera Web interface via the ‘Shutdown Camera’
button box.
Vista de página 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 116 117

Comentários a estes Manuais

Sem comentários