Campbell PC208W Manual do Utilizador descarregar pdf (Página 13)

MicroMet Manual Pg. 10

Warnings and Advisories

MicroMet may issue various advisories or warnings to indicate a change in system

status. Advisories are simply a way for MicroMet to advise you of a normal change of

status. Warnings are meant to get your attention, and to warn you of an unexpected

problem. Warnings are always issued without regard to the verbosity level, while

advisories are keyed to the verbosity level. The higher the verbosity level the more

advisories will be issued.

ADVISORY

YY/MM/DD HHMM New data Msg:…

This advisory indicates that MicroMet has received a new data message from

the CR10X. This new message is immediately enqueued for delivery to AMBCS.

This advisory is displayed at a verbosity level 5 and above.

ADVISORY

YY/MM/DD HHMM Message delivered to Master Station.

This advisory indicates the data message has been delivered and

acknowledged by the Master Station. The message is immediately dequeued.

This advisory is displayed at a verbosity level

WARNING

YY/MM/DD HHMM HiVSWR! Check antenna System.

This warning indicates that the radio transmitter has detected a bad antenna or

transmission line. If this condition persists, no communication will occur. Check

the antenna for proper assembly and broken components. Check the coaxial

transmission line for continuity, good connections, etc. See Troubleshooting,

pgs 19-23). This warning may also accompany the HiVSWR warning as the

transmitter does shut down during a HiVSWR event.

WARNING

YY/MM/DD HHMM Low Transmitter Power!

This warning indicates that the radio transmitter is not developing the proper

level of transmit power. Check the capacity of the system battery and

connections. This warning may also accompany the HiVSWR warning as the

transmitter does shut down during a HiVSWR event.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 28 29

Sem comentários

Campbell PC208W Manual do Utilizador Página 13