Campbell RAWS-H Remote Manual descarregar pdf (Página 18)

RAWS-H Remote Automated Weather Station

5.5.3 Troubleshooting, Voice Radio Interface (part #VSP3)

If a problem with the voice radio interface (part #VSP3) is suspected, the VSP3

may be checked by measuring the +12 V and Ground terminal on the VSP3.

Acceptable readings are +11 VDC to +14 VDC. Verify the sensor wires are

securely fastened to the VSP3 connector and the CR1000 printed circuit board

wiring panel. If problems persist, try a substitute.

5.6 CR1000 Keyboard/Display

5.6.1 General Description, CR1000 Keyboard/Display (part #CR1000KD)

The CR1000 Keyboard/Display (part #CR1000KD) shown in Figure 5.6-1 is

used to check datalogger status, display or plot sensor readings and stored

values, and to enter numeric data or change port/flag state. The CR1000KD is

powered from the CR1000 printed circuit board “CS I/O” connector via a

standard 9-pin serial cable (part #10873) that ships with the RAWS station.

Power Up Screen

Press any key for Power up Screen

Press ^ to turn on/off backlight

Press <> to adjust contrast

RAWS-H Setup Screen

Press up/down arrow to select menu item

Press Enter to see menu choices

Press up/down arrow to highlight menu choice

Press Enter to select menu choice

Press Esc to move up a menu

Press Enter to move down a menu

FIGURE 5.6-1. CR1000 Keyboard/Display

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Sem comentários

Campbell RAWS-H Remote Manual Página 18