Campbell RAWS-P Manual descarregar pdf (Página 12)

RAWS-P Remote Automated Weather Station

Use the CR1000KD Keyboard Display to see the

“Public Variables” shown in Table 2-1.

NOTE

• Connect the CR1000KD Keyboard Display to

the CS I/O connector (Figure 5.7-2) or SC12

Cable (Figure 2-1)

• Press any key for the CR1000KD Power up

Screen

• Press Enter to move down a menu (Press Esc

to move up a menu)

• (Press up/down arrow to select item)

• Select Data, press Enter

Press any key for Power up Screen

Press ^ to turn on/off backlight

Press <> to adjust contrast

• Select Real Time Tables, press Enter

• Select Public, press Enter

• Press up/down arrow to see the Public Variables listed in Table 2-1

TABLE 2-1. Public Variables

Number Name Function

Sensor Variables

1 Batt_Volt System power supply voltage

2 AirTempF HC2S3 Air Temperature in Degrees F

3 RH HC2S3 Relative Humidity in Percent

4 TdewF Dew point in Deg F, calculated from HC2S3 data

5 SlrW Solar Radiation in Watts, pyranometer

6 Rain_in Temporary rain, cleared every scan

7 RainTot TE525 Cumulative rain fall in inches

8 WS_mph Wind Speed in MPH

9 WindDir Wind Direction

10 WSDiag Only for Wind Sonic data, zero otherwise

11 MaxWS MaxWS, reset 2 minutes before transmit

12 MaxWD Direction of wind during Max wind speed

13 SlrMJ Solar Radiation in MJoules

14 BP_inHg Hourly - Barometric pressure, inHg

15 BPelev_ft Elevation, to correct Barometric pressure

16 FuelT_F Hourly - Fuel temperature in degrees F

17 FuelM Hourly - Fuel Moisture, % moisture by weight

GOES Variables

18 CountDwn True or False: True indicates GPS fix good and program is collection data. False

until GPS fix

19 Clockgood True or False: True after GPS fix and CR1000 clock has been set to match

TX320 clock

20 TimeToXmit Seconds until transmit time. Indicates CR1000 and TX320 are properly setup

and running

21 SWR Standing Wave Ratio (SWR), only after a transmission. Indicates condition of

antenna and cable. SWR should be less than 2.0

22 FwdPower Forward Power in dBm, should be about 37

23 RefPower Reflected power in dBm, should be about 25 or less

24 RC_Data Only valid after first transmission. Anything other than zero is a problem

25 Setup_RC Indicates if CR1000 could setup TX320. Zero is success or has not run

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Comentários a estes Manuais

Sem comentários

Campbell RAWS-P Manual Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Estações meteorológicas Campbell RAWS-P