Campbell AVW200 series Manual de Instruções descarregar pdf (Página 23)

APPENDIX E –LOGGERNET QUICKSTART GUIDE

E.1 Overview

Campbell Scientific’s LoggerNet Software is used to communicate with the Datalogger,

program user specific settings and collect Data stored in the Datalogger memory.

LoggerNet is designed to be used with Geokon Micro-1000 and Micro-800 Dataloggers

reading Vibrating Wire and MEMS tilt sensors; other configurations and sensor outputs

are available upon request. Geokon provides the user with a generic Start Program to

simplify acquiring Data without the need to be proficient in Campbell Scientific CRBasic

programming code. The Start Program(s) will be pre-configured with a default Scan

Interval and will store Raw Units by default. Each Start Program will have two associated

files on the factory supplied USB flash drive. The first is the Main CRBasic program

(.CR1/.CR8) and includes all programming code required to read and store Data

according to the Datalogger configuration. The Main CRBasic program does not require

modification by the user in most cases. The second file is the Include (.DLD) text file and

is used by the Main program to import user specific parameters. The Include file allows

program parameters such as the Scan Interval, Zero Readings, Linear Gage Factors, Data

File Header Labels and Temperature Correction factors to be modified by the user.

E.2 Getting Started

E.2.1 Program Files

After installing LoggerNet, the CRBasic program files are located on the Geokon USB

Thumb Drive. The file types are “.DLD” and “.CR1”/“.CR8.”, these files should first be

copied to the end users computer in C:\Campbellsci\CRBasicEditor.

E.2.2 Connection Setup

The Launch Menu provides a drop-down list of all the categories on the LoggerNet

toolbar. Hovering over a category will display a list of applications related to that

category.

With the Launch Menu open, hover over “Main” and press “Setup” from the resulting list

of applications.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 46 47

Sem comentários

Campbell AVW200 series Manual de Instruções Página 23