Campbell AVW200 series Manual de Instruções descarregar pdf (Página 82)

Appendix D. The Public Table

Values and Control Parameters for SDI-12 Communications

SDI12val(1) Frequency value obtained by SDI Recorder Instruction, if

used; unchanged if not using SDI-12.

SDI12val(2) Amplitude value obtained by SDI Recorder Instruction, if

used; unchanged if not using SDI-12.

SDI12val(3) Signal to noise ratio obtained by SDI Recorder

Instruction, if used; unchanged if not using SDI-12.

SDI12val(4) Signal to noise frequency obtained by SDI Recorder

Instruction, if used; unchanged if not using SDI-12.

SDI12val(5) Decay ratio obtained by SDI Recorder Instruction, if used;

unchanged if not using SDI-12.

SDI12val(6) Thermistor reading obtained by SDI Recorder Instruction,

if used; unchanged if not using SDI-12.

SDIChan Channel used for SDI-12 measurement

SDIBFreq Begin frequency used for SDI-12 measurement

SDIEFreq End frequency used for SDI-12 measurement

SDIExVolt Excitation voltage used for SDI-12 measurement

Value of Last Instruction That’s Running

Ch1Freq Frequency value measured on channel 1

Ch1Amp Amplitude value measured on channel 1

Ch1SNR Signal to noise ratio measured on channel 1

Ch1SNRFreq Signal to noise frequency measured on channel 1

Ch1Decay Decay ratio measured on channel 1

Ch1Therm Thermistor reading measured on channel 1

Ch2Freq Frequency value measured on channel 2

Ch2Amp Amplitude value measured on channel 2

Ch2SNR Signal to noise ratio measured on channel 2

Ch2SNRFreq Signal to noise frequency measured on channel 2

Ch2Decay Decay ratio measured on channel 2

Ch2Therm Thermistor reading measured on channel 2

D-2

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 113 114

Sem comentários

Campbell AVW200 series Manual de Instruções Página 82