Campbell RF410 Manual de Instruções descarregar pdf (Página 104)

Appendix F. CR510PB w/ P193 Master to CR205s Network

F-6

from SE1 to

and the 10KΩ resistor from EX1 to SE1. The result will

be a simulated temperature reading of 22°C ± 2 degrees.

2. Configure a CR510PB PakBus address of “100” in Edlog’s

Options\Pakbus Settings:

FIGURE F-2. P193 Edlog PakBus Settings

The maximum nodes, maximum neighbors, and maximum routers entries

allow the CR510PB to function as a router in the network.

Notice that “Network” is the only setup group unchecked. There is no need

of Neighbor Filter or Beacon setup because the P193 creates a static route

to each CR205 in the swath.

3. Save and compile the program as P193TRANSFER.dld

4. Send the program to the CR510PB

5. Configure a Numeric Display in Connect Screen showing the CR510PB’s

Input Locations to monitor the remote CR205s’ variables. You can click

and drag to organize the display Input Locs to look something like this.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 123 124

Sem comentários

Campbell RF410 Manual de Instruções Página 104