Campbell RF410 Manual de Instruções descarregar pdf (Página 92)

Appendix E. CR510PB w/ P190s to CR205s Network

E-2

LoggerNet Device Map

ComPort_1

PhoneBase

PhoneRemote

PakBusPort

CR510PB (PakBus Address = 100)

CR200_1 (PakBus Address = 1)

CR200_2 (PakBus Address = 2)

CR200_3 (PakBus Address = 3)

CR200_4 (PakBus Address = 4)

CR200_5 (PakBus Address = 5)

After once dialing up and connecting in LoggerNet, PakBusGraph will display

the CR510PB and all its CR205 neighbors.

LoggerNet Schedule Tab

Collection Interval – 15 minutes

Primary Retry Intervals – 5 minutes

Number of Primary Retries – 2

Secondary Retry Interval – 60 minutes

RF400 Settings

In a PakBus rf network, all radios are set up with the exact same radio and

network address and hopping sequence.

1. Configure RF400 radio with the same Radio Address, Net Address, and

Hopping Sequence as the CR205s. If there will be no other RF400s in the

area, you can use default settings, otherwise choose some other settings

and configure all alike.

2. Other Settings

Active Interface = “CSDC 7” (7 is default. It could be changed to 8 if no

other peripheral uses 8).

Standby Mode = “< 24 mA always on” (other modes work in some

situations if other network radios are the same).

CR205 Settings and Program

1. Configure all CR205s with the same hopping sequence, radio address, and

network address using the same settings as the RF400 has.

2. Configure each CR205 with a unique PakBus address (“Datalogger

Address” in PakCom) starting with “1” and ending with “5.”

3. Configure CR205 Power Mode = RF_ON.

Configure CR205 Radio Force On = 0.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 123 124

Sem comentários

Campbell RF410 Manual de Instruções Página 92