Campbell RF410 Manual de Instruções descarregar pdf (Página 82)

Appendix B. NL100 TcpServer to RF400 to CR510PB-Router/RF400 to 20 CR205s Network

B-2

LoggerNet Schedule Tab

Collection Interval – 60 minutes

Primary Retry Intervals – 20 minutes

Number of Primary Retries – 2

Secondary Retry Interval – 240 minutes

NL100 Configuration Menu Settings

(Any NL100 options not shown above are disabled).

A PakBus Address is required by setup even though not used.

RF400 Settings

In a PakBus rf network all radios must have the same radio and network

addresses and hopping sequence setting. Addressing is accomplished using the

unique PakBus addresses assigned to the PakBus devices (dataloggers).

1. Configure both RF400 radios with the same Radio Address, Net Address,

and Hopping Sequence. If there will be no other RF400s within range, you

can use default settings.

2. RF400 connected to NL100

Active Interface = “AutoSense”

Standby Mode = “< 24 mA always on”

3. RF400 connected to CR510

Active Interface = CSDC 7 (7 is default but you could configure 8)

Standby Mode = < 24 mA

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 123 124

Sem comentários

Campbell RF410 Manual de Instruções Página 82